DESCRIPTION

The s390_runtime_instr() system call starts or stops CPU run-time instrumentation for the calling thread.

The command argument controls whether run-time instrumentation is started (S390_RUNTIME_INSTR_START, 1) or stopped (S390_RUNTIME_INSTR_STOP, 2) for the calling thread.

The signum argument specifies the number of a real-time signal. This argument was used to specify a signal number that should be delivered to the thread if the run-time instrumentation buffer was full or if the run-time-instrumentation-halted interrupt had occurred. This feature was never used, and in Linux 4.4 support for this feature was removed; thus, in current kernels, this argument is ignored.

RETURN VALUE

On success, s390_runtime_instr() returns 0 and enables the thread for run-time instrumentation by assigning the thread a default run-time instrumentation control block. The caller can then read and modify the control block and start the run-time instrumentation. On error, −1 is returned and errno is set to indicate the error.

ERRORS

VERSIONS

This system call is available since Linux 3.7.

CONFORMING TO

This Linux-specific system call is available only on the s390 architecture. The run-time instrumentation facility is available beginning with System z EC12.

NOTES

Glibc does not provide a wrapper for this system call; call it using syscall(2)

The asm/runtime_instr.h header file is available since Linux 4.16.

Starting with Linux 4.4, support for signalling was removed, as was the check whether signum is a valid real-time signal. For backwards compatibility with older kernels, it is recommended to pass a valid real-time signal number in signum and install a handler for that signal.

SEE ALSO

syscall(2), signal(7)